ما العمل عند تشقق GRC؟ شرح تقنية إصلاح تشققات GRC من تشينغلونغ

Cracks in GRC products require targeted repair solutions based on factors such as crack nature, width, and location. Based on 28 years of engineering experience, Qinglong GRC has established a complete technical system for crack assessment and repair.

In the Shanghai Century Plaza renovation project, some GRC decorative lines developed fine cracks. Through on-site inspection, the Qinglong technical team classified the cracks into three categories: micro-cracks narrower than 0.2mm were treated with surface sealing; cracks of 0.2-0.5mm were repaired with low-pressure grouting; structural cracks wider than 0.5mm were addressed with a grooving and filling solution. After repair, third-party testing showed a strength recovery rate of over 95%, with the appearance consistent with the original state. The crack repair standards established for the project, including material mix ratios, construction procedures, and acceptance criteria, ensured repair quality.

Micro-crack Sealing Treatment

Cracks narrower than 0.2mm are treated with the surface sealing method. A special penetrating sealant is applied 2-3 times, with 4-6 hours between coats to ensure full penetration. After treatment, the surface regains its waterproof function.

Medium Crack Grouting Repair

Cracks of 0.2-0.5mm are repaired with low-pressure grouting technology. Modified epoxy resin grout is used, with pressure controlled at 0.2-0.5MPa. Grouting starts from the bottom end of the crack and advances slowly upward to ensure dense filling.

Comprehensive Treatment of Structural Cracks

Cracks wider than 0.5mm require grooving and filling. The groove is 20-30mm wide and 15-20mm deep. Polymer repair mortar is applied in layers, with each layer no thicker than 10mm. The surface regains its decorative finish.

Measures to Prevent Recurrence

Analyze the causes of cracks and take preventive measures: expansion joints for temperature cracks, reinforced support for load-induced cracks, and optimized procedures for construction cracks. This solves the problem at its root.

Crack repair requires professional judgment. It is recommended to entrust an experienced team to ensure repair effectiveness and safety in use.